简介

Computer not holding a charge? Tired of looking for outlets everywhere you go? Change your HP Stream battery!

  1. Use a plastic spudger to remove two oblong screw covers on the bottom of the computer.
    • Use a plastic spudger to remove two oblong screw covers on the bottom of the computer.

    • Use a plastic spudger to remove four rubber feet.

    • To remove the feet you must break the glue seal holding them down.

    添加评论

  2. Remove the eleven 5 millimeter housing screws from the bottom of the computer using a #00 Phillips head screwdriver.
    • Remove the eleven 5 millimeter housing screws from the bottom of the computer using a #00 Phillips head screwdriver.

    添加评论

    • Turn the computer over and open it.

    • Use a plastic spudger to pry the keyboard bezel away from the base. Pry around the edge, being careful not to jam the spudger too far underneath the bezel (potentially damaging internal components).

    • The bezel is tightest near the hinge.

    • Once the bezel is free, do not lift it away from the base.

    添加评论

    • Identify two ribbon connectors and the ZIF cable underneath the keyboard.

    • Use tweezers to disconnect both ribbon cables and the ZIF connector.

    添加评论

    • Use a Phillips #00 screwdriver to remove six 5 millimeter screws from the battery.

    添加评论

    • Use a plastic spudger to remove the two power connectors.

    • Lift the battery out.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 9

过去的30天: 45

总计 233