Shut the device off.
  • Shut the device off.

  • Lift the top cover of the scanner.

  • Carefully, pry the plastic frame surrounding the glass away from the printer hood using a plastic prying tool.

  • Pull the frame out.

添加评论

Unscrew the two screws that fasten the frame to the printer hood. Use a T10 screwdriver
  • Unscrew the two screws that fasten the frame to the printer hood. Use a T10 screwdriver

添加评论

  • Pushing the clip behind the cover piece in, pull the cover piece outwards.

添加评论

  • Remove the two screws on the front of the printer with a T10 screwdriver.

    • The first is inside the power button panel space and the second is across the printer slider.

添加评论

  • Pull the circuit board from the power button panel space.

  • Unplug the small ribbon cable from the circuit board.

添加评论

  • Pull the memory card reader's circuit board out of its slot.

  • Detach the rainbow connector from the back of the circuit board.

添加评论

  • Press the clip directly behind the TouchSmart panel and pull the panel up.

  • Disconnect the ribbon cable from the TouchSmart panel. This detaches the panel from the printer body.

  • Do not hesitate to use force to remove the TouchSmart panel.

添加评论

  • Grip the printer hood and pull upward.

添加评论

  • Lift the scanning lid from the lower portion of the printer hood.

Remove torx screw on bottom of assembly in corner near touchsmart screen space.

Jeff - 回复

  • Leaving the ribbon connected, lift the sliding scanner off the track.

  • Pull the ribbon cable out of the slot on the scanner circuit board.

  • Insert the scanning piece into the rolling track.

添加评论

结论

To reassemble the sliding scan piece, follow these instructions in reverse order.

Renee Lamb

于2012年09月26日注册

208 信誉积分

创作了3篇指南

团队

Cal Poly, Team 2-11, Propen Fall 2012 Cal Poly, Team 2-11, Propen Fall 2012 的会员

CPSU-PROPEN-F12S2G11

4 名成员

创作了6篇指南

Where can i buy the scaning piece? Im from Spain.

Bogdan Cosmin - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 4

总计 1,213