HP Pavilion x360 11m-ad013dx Speaker Replacement

简介

If the speakers in your HP Pavilion x360 11m-ad013dx are in need of replacement or have stopped functioning properly, use this guide to replace the speakers. For more information about malfunctioning or nonfunctioning speakers, see our troubleshooting page HP Pavilion x360 11m-ad013dx Troubleshooting. The speakers are responsible for producing sound in the laptop. They also give access to work on the motherboard when removed.

你所需要的

步骤 1 Keyboard

HP Pavilion x360 11m-ad013dx Speaker Replacement, Keyboard: 步骤 1 中的图像 1，1

Lay the HP Pavilion top-down with the front edge facing towards you.

编辑

步骤 2

Remove the three 4.8mm Phillips #0 screws from the front side.

编辑

步骤 3

Using a plastic spudger, remove the grey silicon strip closest to the back-side.

编辑

步骤 4

Remove the three 5.7mm Phillips #1 screws.

编辑

步骤 5

Open the HP Pavilion so that the screen is showing. Then tilt it down so that the screen is on its back, facing up.
Using a spudger, pry off the black keyboard panel.
This step requires force to unclasp the latches keeping the keyboard in place.

编辑

步骤 6

Using your fingernail, disconnect the zero insertion force (ZIF) keyboard connector cable by flipping up the small locking flap.
You may disconnect the other end of the cable, for ease of access to other parts. Keep in mind that the end labeled MB connects to the motherboard.

编辑

步骤 7

Using your fingernail, disconnect the zero insertion force (ZIF) connector for the touch pad cable by flipping up the small locking flap.

编辑

步骤 8

Remove the keyboard.

编辑

步骤 9 Battery

HP Pavilion x360 11m-ad013dx Speaker Replacement, Battery: 步骤 9 中的图像 1，1

Remove the five 4.6mm Phillips #1 screws located around the battery.

编辑

步骤 10

Using a spudger for assistance, lift up the right edge of the battery.
Remove the battery.

编辑

步骤 11 Speaker

HP Pavilion x360 11m-ad013dx Speaker Replacement, Speaker: 步骤 11 中的图像 1，2

HP Pavilion x360 11m-ad013dx Speaker Replacement, Speaker: 步骤 11 中的图像 2，2

Using your fingernail, disconnect the ZIF (zero insertion force) hard drive cable by flipping up the small locking flap.

编辑

步骤 12

With your fingernails, disconnect the speaker cable from the motherboard by pulling back on the connector.
Do not directly pull on the wires, as this can damage the connector.

编辑