跳转到主内容

简介

This guide will show how to replace a touch pad in the HP Pavilion x2 10-n113dx. This guide is moderate in difficulty as one must open up the back of the keyboard. It is important to have a heat pad available so that one can reassemble the gray bumper on the back of the keyboard. The replacement guide requires a Phillips #0 screwdriver and a magnetic board is helpful for keeping track of screws.

  1. Separate the screen from the keyboard. Separate the screen from the keyboard.
    • Separate the screen from the keyboard.

  2. Loosen the adhesive under the gray plastic bar using a heat pad or a heat gun.
    • Loosen the adhesive under the gray plastic bar using a heat pad or a heat gun.

    • Remove the gray plastic bar after 5 minutes of light heat with tweezers by pulling up.

  3. Remove the 4 screws with a Phillips #0 screwdriver.
    • Remove the 4 screws with a Phillips #0 screwdriver.

    • These 4 screws have a diameter of 4.3 mm and a height of 3.7 mm.

  4. Remove the rubber stoppers at the top left and right with tweezers. Remove the screws  at the top and right with at Phillips #0 screwdriver.
    • Remove the rubber stoppers at the top left and right with tweezers.

    • Remove the screws at the top and right with at Phillips #0 screwdriver.

    • These two screws have a diameter of 5.3 mm and a height of 4.3 mm.

  5. Pry open the back case with a metal spudger. Then pry open the back layer with the metal spudger. Then pry open the back layer with the metal spudger.
    • Pry open the back case with a metal spudger.

    • Then pry open the back layer with the metal spudger.

  6. Fully take off the back panel by lifting up the panel. Fully take off the back panel by lifting up the panel.
    • Fully take off the back panel by lifting up the panel.

  7. Pop open the ribbon cable piece on the touch pad with the blue plastic spudger. Remove the ribbon cable with tweezers by pulling it out.
    • Pop open the ribbon cable piece on the touch pad with the blue plastic spudger.

    • Remove the ribbon cable with tweezers by pulling it out.

  8. Remove 4 screws with at Phillips #0 screwdriver. All 4 screws have a diameter of 4.3 mm and a height of 3.7 mm. Lift the tape shown with orange boxes with tweezers.
    • Remove 4 screws with at Phillips #0 screwdriver. All 4 screws have a diameter of 4.3 mm and a height of 3.7 mm.

    • Lift the tape shown with orange boxes with tweezers.

    • Remove metal bar with a blue spudger.

  9. Lift up the touch pad by the metal edge with a blue plastic spudger. Remove the touch pad from the computer. Remove the touch pad from the computer.
    • Lift up the touch pad by the metal edge with a blue plastic spudger.

    • Remove the touch pad from the computer.

结论

To reassemble your device, follow these instructions in reverse order.

Cayla Skaggs

于2019年04月01日注册

337 信誉积分

创作了2篇指南

团队

IUPUI, Team S1-G4, Harley Spring 2019 IUPUI, Team S1-G4, Harley Spring 2019 的会员

IUPUI-HARLEY-S19S1G4

3 名成员

创作了3篇指南

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 4

过去的30天: 5

总计 390