简介

A guide to remove and replace the heat sink in the HP Pavilion dv7t-7000.

  1. Turn the computer off and disconnect if from all power sources.
    • Turn the computer off and disconnect if from all power sources.

    添加评论

  2. Slide the battery release switch to the left.
    • Slide the battery release switch to the left.

    添加评论

    • Hold the release switch all of the way to the left and your other hand to pull the battery out.

    添加评论

    • Unscrew the single Phillips #00 screw.

    • Screw will not come out, it is connected to the panel

    添加评论

    • Remove service hatch by sliding away from the computer and lifting up.

    添加评论

    • Remove the single Phillips #00 screw.

    添加评论

    • Pull CD drive out to remove.

    添加评论

    • Push the retraining springs away from the RAM at the same time to unlock the RAM.

    添加评论

    • Pull the RAM out.

    • Follow the same procedure for the additional RAM.

    添加评论

    • Remove the two Phillips #00 screws holding in the hard drive.

    添加评论

    • Grab the black tab on the hard drive and pull left and then upwards to remove.

    添加评论

    • Remove the four Phillips #00 screws holding the hard drive to its case.

    添加评论

    • Slide the casing off of the hard drive.

    添加评论

    • Unplug the hard drive from the device.

    添加评论

    • Use the flat end of a spudger to pop off the antenna connectors.

    添加评论

    • Remove single Phillips #00 screw.

    • Pull the card out by hand.

    添加评论

    • Remove the single Phillips #00 screw.

    • Flip the laptop over.

    添加评论

    • Wedge a spudger in between the keyboard and palm rest bezel.

    • Pry upward to release the keyboard clips.

    • The keyboard is plugged into the motherboard, so be careful not to pull out while lifting keyboard.

    添加评论

    • Use the flat end of a spudger to flip up the black tab on the ZIF connectors.

    • Pull the ribbon cables out of the ZIF connectors.

    • Remove the keyboard.

    添加评论

    • Flip the keyboard back over.

    • Remove the single Phillips #00 screw holding in the CD drive.

    • Pull out the CD drive.

    添加评论

    • Remove the seventeen Phillips #00 screws securing the back panel to the laptop.

    添加评论

    • Flip the laptop over.

    • Remove the single Phillips #00 screw.

    添加评论

    • Remove the panel by lifting it up.

    添加评论

    • Remove the eleven Phillips #00 screws.

    添加评论

    • Use the flat end of a spudger to disconnect all wires connected to the motherboard.

    添加评论

    • Lift up the black tab on the ZIF connector with the flat end of a spudger.

    • Pull the ribbon cable out of the ZIF connector.

    • Remove the fan from the laptop.

    添加评论

    • Once you have removed the motherboard, the heat sink is attached.

    • Flip over the motherboard/heat sink assembly.

    添加评论

    • Remove the six screws holding the heat sink onto the motherboard.

    • Unplug the cord supplying power to the fan.

    • Pull the two pieces apart.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Eric Easley

于2018年02月10日注册

175 信誉积分

创作了2篇指南

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 5

过去的30天: 8

总计 99