简介

A defective button pad is is not difficult to replace with just a couple tools.

配件

无需配件。

  1. Grasp the scanner lid cover from the front of the device and lift lid all the way up until it stands on its own.
    • Grasp the scanner lid cover from the front of the device and lift lid all the way up until it stands on its own.

    添加评论

  2. With two hands, grasp the lid on both sides near the hinges and lift straight up to release the lid from each hinge.
    • With two hands, grasp the lid on both sides near the hinges and lift straight up to release the lid from each hinge.

    添加评论

    • Once you have removed the scanner lid, locate the finger notch on inside the top left half of the bezel (control) panel.

    添加评论

    • Place your index finger in the notch and lift up to unsnap the panel.

    • Set panel cover aside.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use a T9 torx screwdriver to remove the 0.9 cm screw.

    添加评论

    • From the front of the printer, remove the button panel by pulling it towards you while slightly lifting it up.

    添加评论

    • Disconnect the white ribbon cable by grasping it between your thumb and index finger.

    • Gently pull to release the ribbon from the green circuit board

    添加评论

    • Next, use the flat end of a spudger to pry loose the flat ribbon computer cable by the plastic connection end and carefully separate it from the prongs on the button panel.

    • The entire button panel should now be completely disconnected from the printer.

    添加评论

    • Lay the panel on a flat surface with the backside facing up.

    • Using a T9 torx screwdriver, remove all six 0.7 cm silver screws from the off-white plastic panel.

    添加评论

    • Gently lift the button panel off the plastic backing with rubber button mat.

    添加评论

    • Be careful not to lift out and lose the two clear plastic panel separators (these are not fastened to the panel but can easily fall out of the panel if tilted). These are two small plastic parts that sit near the top right and left portions of the panel.

    • Insert your new button panel. To reassemble your printer, follow these instructions in reverse order.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Patricia

于2014年01月23日注册

140 信誉积分

撰写一个指南

团队

TheFixers TheFixers 的会员

Community

2 名成员

创作了1篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 8

总计 686