HP Envy 17-3070NR RAM Replacement

Written By: Abby Lentz (and 3 other contributors)

Comments: 0
Favorites: 1

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Introduction

Use this guide to upgrade your RAM to boost performance or to replace faulty one if you start getting RAM related blink codes, which are explained in the troubleshooting section.

Tools

Buy these tools

Phillips #2 Screwdriver

$2.99

Buy

Parts

No parts required.

Step 1 Back Cover

Before you begin taking apart the computer, make sure that it is completely powered off.

Before you begin taking apart the computer, make sure that it is completely powered off.
Slide the release latch away from the nearest edge.
Slide the back cover off of the computer.

Edit

Step 2

Remove the six 3.7mm Phillips screws.
Slide the back cover until it clicks, then lift it straight off.

Edit

Step 3 RAM

Press down on both tabs on either side of the top RAM stick.
The RAM will slightly pop out and you will be able to slide it out of it's cavity.
Repeat the same process for the second stick of RAM if needed.