跳转到主内容

简介

To replace the SSD Card, or another form of storage for the device, use this guide.

  1. With the screen face down, lift up the stand as far as it goes.
    • With the screen face down, lift up the stand as far as it goes.

    • Make sure not to force it past the resting point.

  2. Use a screwdriver to remove the six screws on the back of the tablet. (The screws were not in our device, so we do not know what kind of screwdriver to use.)
    • Use a screwdriver to remove the six screws on the back of the tablet.

    • (The screws were not in our device, so we do not know what kind of screwdriver to use.)

  3. After removing the screws, delicately close the stand.
    • After removing the screws, delicately close the stand.

    • Flip the tablet on its back so that the screen is facing up.

  4. Use the suction cup to carefully separate the screen from the device. Pull upwards with a fluid and smooth motion. Do not lift too fast! There will still be wires connecting the screen to the device. Make sure they are not tampered with.
    • Use the suction cup to carefully separate the screen from the device. Pull upwards with a fluid and smooth motion.

    • Do not lift too fast! There will still be wires connecting the screen to the device. Make sure they are not tampered with.

  5. Remove the tape on the lower left side of the screen. Underneath the tape, disconnect the LCM cable, the larger wire that was underneath the tape, from the back of the tablet screen. Underneath the tape, disconnect the LCM cable, the larger wire that was underneath the tape, from the back of the tablet screen.
    • Remove the tape on the lower left side of the screen.

    • Underneath the tape, disconnect the LCM cable, the larger wire that was underneath the tape, from the back of the tablet screen.

  6. Disconnect the flex cable from the device using the spudger. Remove the Display Assembly from the device.
    • Disconnect the flex cable from the device using the spudger.

    • Remove the Display Assembly from the device.

  7. Use a Phillips #0 screwdriver to remove the screw on the left hand side of the card.
    • Use a Phillips #0 screwdriver to remove the screw on the left hand side of the card.

  8. Slightly lift the card up and then remove the SSD card from the device.
    • Slightly lift the card up and then remove the SSD card from the device.

    • As you slide it out, make sure it gets unplugged from the port. Do not continue to tug on a stuck port.

结论

To reassemble your device, follow these instructions in reverse order.

Colin Mika

于2018年04月19日注册

893 信誉积分

创作了6篇指南

团队

Cal Poly, Team S24-G7, Maness Spring 2018 Cal Poly, Team S24-G7, Maness Spring 2018 的会员

CPSU-MANESS-S18S24G7

4 名成员

创作了6篇指南

0条评论

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 5

过去的30天: 39

总计 1,811