简介

Use this guide to replace and / or adjust the screen of the HP Elite x2 G1.

配件

无需配件。

  1. With the screen face down, lift up the stand as far as it goes.
    • With the screen face down, lift up the stand as far as it goes.

    • Make sure not to force it past the resting point.

    添加评论

  2. Use a screwdriver to remove the six screws on the back of the tablet.
    • Use a screwdriver to remove the six screws on the back of the tablet.

    • (The screws were not in our device, so we do not know what kind of screwdriver to use.)

    添加评论

    • After removing the screws, delicately close the stand.

    • Flip the tablet on its back so that the screen is facing up.

    添加评论

    • Use the suction cup to carefully separate the screen from the device. Pull upwards with a fluid and smooth motion.

    • Do not lift too fast! There will still be wires connecting the screen to the device. Make sure they are not tampered with.

    添加评论

    • Remove the tape on the lower left side of the screen.

    • Underneath the tape, disconnect the LCM cable, the larger wire that was underneath the tape, from the back of the tablet screen.

    添加评论

    • Disconnect the flex cable from the device using the spudger.

    • Remove the Display Assembly from the device.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Colin Mika

于2018年04月19日注册

773 信誉积分

创作了6篇指南

团队

Cal Poly, Team S24-G7, Maness Spring 2018 Cal Poly, Team S24-G7, Maness Spring 2018 的会员

CPSU-MANESS-S18S24G7

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 8

过去的30天: 33

总计 188