简介

This guide will take you through the process of replacing the screen on an HP Compaq nc6400 Laptop. You will need the correct replacement screen for your laptop to complete the installation.

  1. Turn off and unplug laptop.
    • Turn off and unplug laptop.

    添加评论

  2. Locate the battery lock below the battery labeled one.
    • Locate the battery lock below the battery labeled one.

    • Slide the lock all the way to the left to release the left lock of the battery.

    添加评论

    • Locate the lock labeled two at the bottom right corner below the battery.

    • Slide and hold the lock to the left.

    添加评论

    • Once both the battery locks are unlocked, slide the battery out to remove.

    添加评论

    • Remove the four 1.2mm Philips #1 screws attaching the plastic cover to the monitor.

      • The screws may have a small, black plastic cover that lays flush with the screen. Remove these using a pointed tool such as the spudger or philips head screwdriver by prying them out.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the four 1.2 Philips #1 screws attaching the face plate to the body.

    添加评论

    • Pry up the plastic screen cover using a pry tool.

    • Keeping the pry tool under the trim, slide it around the entire screen until the the cover has completely detached from the base.

      • You might need to slide the display clip on the top of the screen in order to fully remove the plastic cover.

    添加评论

    • Remove the two 1.2 Philips #1 screws holding down the sensor board at the bottom of the monitor.

    添加评论

    • Remove the right-most 1.2mm Philips #1 screw on the bottom of the monitor.

    添加评论

    • Without lifting the bottom of the monitor, gently flip the screen and lay it face down on the keyboard.

    添加评论

    • Remove the tape holding down the video cable to the monitor.

    • Gently pull out the video cable from the monitor.

    添加评论

    • Remove the monitor's power cable from the sensor board.

      • This is the cable on the farthest right of the sensor board.

    添加评论

    • Once all cables attaching the casing to the monitor have been disconnected, remove the entire screen from the computer and lay it on a flat surface.

    • Remove the four 1.2 Philips #1 screws attaching the bezel to the right side of the monitor.

    • Attach bezel to replacement screen.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Luis Vazquez

于2013年09月24日注册

311 信誉积分

创作了2篇指南

团队

Cal Poly, Team 14-6, Forte Fall 2013 Cal Poly, Team 14-6, Forte Fall 2013 的会员

CPSU-FORTE-F13S14G6

5 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 8

过去的30天: 32

总计 3,878