简介

This guide explains how to remove the Motherboard from the HP 15-f009wm notebook computer. This could be done to either replace a malfunctioning Motherboard or to upgrade to a stronger Motherboard.

Turn laptop upside down.
  • Turn laptop upside down.

  • Flip the lock switch to the unlocked setting.

添加评论

Flip the release switch.
  • Flip the release switch.

  • Once the flip is switched, the battery should pop out.

添加评论

  • Slide the battery out.

添加评论

  • Remove the two Phillips #1 screws from the RAM panel.

添加评论

  • Use the plastic opening tool to pop the panel off.

添加评论

  • Release the tabs on each side of the chip by simultaneously pushing each tab away from the RAM.

  • These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

添加评论

  • Remove the RAM chip from the laptop.

添加评论

  • Remove the sixteen 7mm Phillips #1 screws from the bottom panel.

添加评论

  • Pull the disk drive out of the laptop.

添加评论

  • Remove the three 2mm Phillips #00 screws found underneath the disk drive.

添加评论

  • Remove the single 4mm Phillips #1 screw from the Wi-Fi card.

  • Pull the Wi-Fi card out of the motherboard.

添加评论

  • Open the laptop.

  • Use a plastic opening tool to pop out the keyboard by starting at the top and working your way around the perimeter.

添加评论

  • Open the screen up until it lays flat and rotate the laptop until the screen is closest to you.

  • Lift the keyboard from the laptop.

  • Use a spudger to lift up the black latch on the ZIF connector and remove the ribbon cable.

添加评论

  • Remove the five 7mm Phillips #1 screws found underneath the keyboard.

添加评论

  • Use a spudger to lift the black tabs on the ZIF connectors.

  • Remove the ribbon cables from the ZIF connectors.

添加评论

  • Use a plastic opening tool to pop the palm rest off of the laptop.

  • Lift and remove the palm rest.

添加评论

  • Use a spudger to lift up the black latch on the ZIF connector.

  • Remove the USB/AUX port ribbon cable from the ZIF connector on the motherboard.

添加评论

  • Remove the single 7mm Phillips #1 screw from the USB/AUX board.

  • Remove the USB/AUX board from the laptop.

添加评论

  • Lift the Hard Drive from the laptop.

  • Disconnect the hard drive from the motherboard.

添加评论

  • Remove the four 4mm Phillips #1 screws from the motherboard.

  • Lift the motherboard up from the computer.

    • There will be three wires connected underneath.

添加评论

  • Disconnect the speaker.

添加评论

  • Remove the display connection wire. Lift the connection straight up from the motherboard.

添加评论

  • Flip the motherboard over.

  • Disconnect the charging port wire from the motherboard.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Alex Birchler

于2018年02月14日注册

733 信誉积分

创作了5篇指南

团队

USF Tampa, Team S2-G2, Nance Spring 2018 USF Tampa, Team S2-G2, Nance Spring 2018 的会员

USFT-NANCE-S18S2G2

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 18

总计 86