跳转到主内容

简介

Use this guide to remove and replace your broken landing gear. It will show you how to remove the entire assembly safely for replacement. This may be needed if broken on a rough landing.

配件

没有特定配件。

  1. Hook your fingers on the tab and pull out the battery.
    • Hook your fingers on the tab and pull out the battery.

  2. Locate stabilizer collar’s unlock and lock symbols. Twist the collar counterclockwise to unlock the stabilizer from GoPro Karma body. Place the GoPro Karma on a stable surface with the legs folded in and the stabilizer facing towards yourself. Place the GoPro Karma on a stable surface with the legs folded in and the stabilizer facing towards yourself.
    • Locate stabilizer collar’s unlock and lock symbols. Twist the collar counterclockwise to unlock the stabilizer from GoPro Karma body.

    • Place the GoPro Karma on a stable surface with the legs folded in and the stabilizer facing towards yourself.

  3. Remove the stabilizer by pulling the entire stabilizer out of the drone body.
    • Remove the stabilizer by pulling the entire stabilizer out of the drone body.

  4. Flip the drone upside down with the landing gear out.
    • Flip the drone upside down with the landing gear out.

    • Remove the four 1.2 cm long hex screws with a Hex 2.0 screwdriver in the four corners of the landing gear

  5. Push with your thumb and pull up with your fingers to remove the landing gear.
    • Push with your thumb and pull up with your fingers to remove the landing gear.

    • Caution: The landing gear is connected by a thin cable so do not pull too far away.

  6. Flip over the landing gear and locate the cable connector. Use your thumbnail to disconnect the cable and free the landing gear.
    • Flip over the landing gear and locate the cable connector.

    • Use your thumbnail to disconnect the cable and free the landing gear.

结论

To reassemble your device, follow these instructions in reverse order.

Jay Ingram

于2018年04月19日注册

310 信誉积分

创作了3篇指南

团队

Cal Poly, Team S25-G14, Maness Spring 2018 Cal Poly, Team S25-G14, Maness Spring 2018 的会员

CPSU-MANESS-S18S25G14

4 名成员

创作了6篇指南

0条评论

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 2

总计 417