跳转到主内容

简介

This guide will explain how to replace the power supply cable of the General Electric Bagel Switch 4-Slice toaster.

  1. Unplug the toaster from the electrical outlet.
    • Unplug the toaster from the electrical outlet.

  2. Remove the two levers and four dials by pulling them out directly towards you. Removing these components may require some force, but they will release.
    • Remove the two levers and four dials by pulling them out directly towards you.

    • Removing these components may require some force, but they will release.

  3. Look for the plastic clips on the back side of the toaster.
    • Look for the plastic clips on the back side of the toaster.

    • Disconnect the small plastic clips on the back of the toaster. Use Philips head Screwdriver to do this step.

    • Now, carefully remove the toaster casing.

  4. Flip the toaster over so that the bottom plate is facing up.
    • Flip the toaster over so that the bottom plate is facing up.

  5. PC 笔记本电池

    所有顶级PC品牌的电池均以我们的质量保证为后盾。

    现在开始购物

    PC 笔记本电池

    所有顶级PC品牌的电池均以我们的质量保证为后盾。

    现在开始购物
  6. Remove the four screws from the bottom of the toaster. Remove the four screws from the bottom of the toaster.
    • Remove the four screws from the bottom of the toaster.

    • Carefully separate the bottom plate from the metal components inside the toaster.

  7. Using wire cutters, cut the power supply cable close to the base of the toaster, leave about 2 inches of wire.
    • Using wire cutters, cut the power supply cable close to the base of the toaster, leave about 2 inches of wire.

  8. Pull the power supply cord through the bottom plate of the toaster.
    • Pull the power supply cord through the bottom plate of the toaster.

    • Insert the end of the new power supply cable through the hole in the bottom plate.

  9. Strip about an inch of the wire insulation (casing) off the ends of both the new power supply cable, and the old power supply cable that is still attached to the toaster.
    • Strip about an inch of the wire insulation (casing) off the ends of both the new power supply cable, and the old power supply cable that is still attached to the toaster.

    • Splice the stripped ends of wire together using a wire cap.

结论

To reassemble your device, follow these instructions in reverse order.

Ron Gajdos

于2013年10月16日注册

307 信誉积分

创作了3篇指南

团队

UMass Dartmouth, Team 4-4, Vijaybhaskar Fall 2013 UMass Dartmouth, Team 4-4, Vijaybhaskar Fall 2013 的会员

UMASSD-VIJAYBHASKAR-F13S4G4

3 名成员

创作了4篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 323