跳转到主内容

简介

You will remove the back cover, remove screws from the fan and heat sink, and take out the fan from the laptop.

配件

没有特定配件。

  1. Place the laptop so the back cover is facing up.
    • Place the laptop so the back cover is facing up.

  2. Remove the 8 screws from the back cover using the Phillips #00 screwdriver.
    • Remove the 8 screws from the back cover using the Phillips #00 screwdriver.

  3. Lift off the cover.
    • Lift off the cover.

  4. Macbook 电池维修套装

    起价 $69.99

    Buy Now

    Macbook 电池维修套装

    起价 $69.99

    Buy Now
  5. Unplug the fan’s power cable, which is a group of black wires attached to a white plastic head on the motherboard.
    • Unplug the fan’s power cable, which is a group of black wires attached to a white plastic head on the motherboard.

    • Pull the plastic part of the cable, not the wires, so that the plug does not break.

  6. Remove the two screws located on opposite sides of the fan with a Phillips #00 screw driver.
    • Remove the two screws located on opposite sides of the fan with a Phillips #00 screw driver.

  7. The fan is permanently attached to the silver heat sink next to the RAM.
    • The fan is permanently attached to the silver heat sink next to the RAM.

    • To completely remove the parts, loosen the heat sink’s four screws with a Phillips #00 screw driver.

    • Take out the screws in the numerical order shown on the heat sink.

  8. Pull the fan and heat sink toward you at a 20 degree angle upward.
    • Pull the fan and heat sink toward you at a 20 degree angle upward.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Toni Pipes

于2010年10月05日注册

297 信誉积分

创作了7篇指南

团队

Cal Poly, Team 21-31, Regan Fall 2010 Cal Poly, Team 21-31, Regan Fall 2010 的会员

CPSU-REGAN-F10S21G31

4 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 5

总计 4,708