简介

If the buttons are unresponsive or sticking, the keypad may be compromised and need to be replaced. This is a guide to replace the keypad buttons of the Garmin GPSmap 60CSx.

配件

无需配件。

Lift and twist the battery cover release  90 degrees counterclockwise on the back of the device.
  • Lift and twist the battery cover release 90 degrees counterclockwise on the back of the device.

添加评论

Lift battery release up to remove battery cover.
  • Lift battery release up to remove battery cover.

添加评论

  • Pull AA batteries out.

添加评论

  • Remove the six 10 mm screws on the back of the device with a Phillips #0 Screwdriver.

  • Flip the back panel over to view the green electronics board (the PCB) and the PCB covering.

  • Remove the black, yellow, blue, and red wires connected to the PCB with light force.

添加评论

  • Place the spudger in the bottom right corner of the black PCB cover and pry the corner out.

    • The previous step will need to be done to the other three corners.

  • It is best to do the two bottom corners first.

  • Pull the black PCB board out of the GPSMap 60 CSx.

添加评论

  • Carefully use spudger to lift the PCB a few centimeters.

  • Pull the PCB out towards the bottom of the GPSMap 60CSx.

  • This will pull out all the main components including the antenna and the screen.

添加评论

  • Take the front panel and apply light force to the buttons.

  • The buttons are part of one unit and should all pop out at once.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Thomas Humphrey

于2018年04月05日注册

519 信誉积分

创作了4篇指南

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 6

过去的30天: 33

总计 190