GameStop GS3 GameCube Controller Buttons Replacement

简介

After many hours of use, the buttons on the Gamecube Controller can become too loose or stick. This guide will provide instructions on how to replace the buttons of the GameStop GS3 Gamecube Controller. There are ten total buttons in this controller: left and right triggers, Z, turbo, D-pad, start/pause, A, B, X, and Y.

你所需要的

步骤 1 Back Panel

GameStop GS3 GameCube Controller Buttons Replacement, Back Panel: 步骤 1 中的图像 1，3

GameStop GS3 GameCube Controller Buttons Replacement, Back Panel: 步骤 1 中的图像 2，3

GameStop GS3 GameCube Controller Buttons Replacement, Back Panel: 步骤 1 中的图像 3，3

First, remove the 6 screws in the back panel and pull the back panel off.
Separate the halves of the controller. However, be careful when separating due to the little wires that could get mixed up.

编辑

步骤 2

GameStop GS3 GameCube Controller Buttons Replacement: 步骤 2 中的图像 3，3

Next, remove the rumble motor by unscrewing the 2 screws connecting it.

编辑

步骤 3

GameStop GS3 GameCube Controller Buttons Replacement: 步骤 3 中的图像 3，3

Finally remove the screws holding in the right and left triggers. It's easiest to hold the trigger together as shown in the third picture. Remove both the left and right trigger, and then you have successfully removed your back panel.

编辑

步骤 4 Buttons

GameStop GS3 GameCube Controller Buttons Replacement, Buttons: 步骤 4 中的图像 1，1

Hold the controller as shown in the picture so that you can remove the circuit board.
The locations of screws to be removed in future steps are shown in red.

编辑