Game Boy Outer Case Replacement - iFixit 维修指南

本指南有最近更改，您可查看未经巡查的最新版本。

简介

This guide explains how to remove the outer case so that you can access the internal components of the Game Boy. This will be helpful for other guides related to this hand-held gaming console.

你所需要的

步骤 1 Batteries

Game Boy Outer Case Replacement, Batteries: 步骤 1 中的图像 1，2

Game Boy Outer Case Replacement, Batteries: 步骤 1 中的图像 2，2

Switch your Game Boy off and remove the cartridge.

步骤 2

Game Boy Outer Case Replacement: 步骤 2 中的图像 1，3

Game Boy Outer Case Replacement: 步骤 2 中的图像 2，3

Game Boy Outer Case Replacement: 步骤 2 中的图像 3，3

Use a fingernail (or small coin) to push down on the battery door latch and remove the battery door.
The release latch is a plastic spring clip. If your Game Boy is getting on in years, be careful as the plastic may be brittle.
When you're replacing the cover, be sure to get its two plastic tabs into the slots in the bottom of the battery compartment before pushing the cover back in place.

步骤 3

Game Boy Outer Case Replacement: 步骤 3 中的图像 1，2

Game Boy Outer Case Replacement: 步骤 3 中的图像 2，2

Use a fingernail to pry each battery outward from the positive (+) terminal to remove them.
Dispose of used batteries properly!
Remove the batteries from your Game Boy before storing it for more than a month or so.

步骤 4 Outer Case

Game Boy Outer Case Replacement, Outer Case: 步骤 4 中的图像 1，1

Remove the six Triwing screws from the back of the device.

步骤 5

Game Boy Outer Case Replacement: 步骤 5 中的图像 1，1

Gently separate the device's front casing from the back casing after you remove the screws.
Be careful not to completely separate the casing halves, as they are still joined by a large ribbon cable that may be damaged.

步骤 6

Game Boy Outer Case Replacement: 步骤 6 中的图像 1，1

Slide the front side of the casing down to expose the ribbon cable connector.

步骤 7

Game Boy Outer Case Replacement: 步骤 7 中的图像 1，1

Grip the ribbon connector with your thumb and forefinger. Pull down gently until the connector, not the ribbon itself, comes out of its socket.
Separate the front and back casings.

结论

To reassemble your device, follow these instructions in reverse order.

13等其他人完成本指南。

作者

与21其他贡献者

Andrew Tramposch

于06/24/10注册

2,243 声望

创作了6篇指南

+ 14更多徽章

团队

Cal Poly, Team 3-2, Johann Summer 2010 Cal Poly, Team 3-2, Johann Summer 2010 的会员

CPSU-JOHANN-R10S3G2

3 名成员

创作了34篇指南

2条评论

U need a tri-wing screwdriver not a Philips #00

radiofreeroyaloak - 2011年11月26日回复

It is a Philips if gb was made after 1998 or so.

Sam - 2016年1月25日回复

浏览统计数据:

过去 24 小时： 0

过去 7 天： 0

过去 30 天： 2

总计 15,686