简介

This guide will illustrate how to install a new headphone jack on an original Game Boy system. You'll need to know how to solder for this replacement, so be sure to check out iFixit's soldering technique guide.

Switch your Game Boy off and remove the cartridge.
  • Switch your Game Boy off and remove the cartridge.

添加评论

Use a fingernail (or small coin) to push down on the battery door latch and remove the battery door.
  • Use a fingernail (or small coin) to push down on the battery door latch and remove the battery door.

    • The release latch is a plastic spring clip. If your Game Boy is getting on in years, be careful as the plastic may be brittle.

    • When you're replacing the cover, be sure to get its two plastic tabs into the slots in the bottom of the battery compartment before pushing the cover back in place.

添加评论

  • Use a fingernail to pry each battery outward from the positive (+) terminal to remove them.

    • Dispose of used batteries properly!

    • Remove the batteries from your Game Boy before storing it for more than a month or so.

添加评论

  • Remove the six Triwing screws from the back of the device.

添加评论

  • Gently separate the device's front casing from the back casing after you remove the screws.

    • Be careful not to completely separate the casing halves, as they are still joined by a large ribbon cable that may be damaged.

添加评论

  • Slide the front side of the casing down to expose the ribbon cable connector.

添加评论

  • Grip the ribbon connector with your thumb and forefinger. Pull down gently until the connector, not the ribbon itself, comes out of its socket.

  • Separate the front and back casings.

添加评论

  • The headphone jack is located on the bottom of the rear outer casing, near the battery compartment.

  • Use a Phillips #00 screwdriver to remove the two screws holding the headphone jack in place.

添加评论

  • Once the headphone jack is detached it will dangle by the wires attached to the main circuit board. Do not worry about the connections, they are solid and will not break.

  • Use a Phillips#00 screwdriver to remove the two screws that hold the main circuit board to the casing. This will allow access to the connection points of the headphone jack.

添加评论

  • Use a plastic opening tool to remove the main circuit board from the casing.

  • Once the main circuit board is removed, set aside the outer casing.

添加评论

  • Desolder the four wires connecting the headphone jack to the motherboard.

  • Desolder the four wires connected to the headphone jack

  • To learn more about soldering, check out iFixit's soldering technique guide.

  • Remove the headphone jack with tweezers.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

10等其他人完成本指南。

Andrew Tramposch

于2010年06月24日注册

1,496 信誉积分

创作了11篇指南

团队

Cal Poly, Team 3-2, Johann Summer 2010 Cal Poly, Team 3-2, Johann Summer 2010 的会员

CPSU-JOHANN-R10S3G2

3 名成员

创作了11篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 11

过去的30天: 78

总计 12,516