简介

This guide provides instructions for removing and replacing the speakers on your Fujitsu LIFEBOOK P7010D.

  1. Place the laptop upside down on a table.
    • Place the laptop upside down on a table.

    Place the laptop upside down on a table. (to the point...)

    Bruce - 回复

    Why is it asking me for a second comment?

    Bruce - 回复

  2. Locate the battery (the grey block). Find the two tabs on one end of the battery near the side of the laptop.
    • Locate the battery (the grey block). Find the two tabs on one end of the battery near the side of the laptop.

    • Using your fingers, press both tabs down at once until they are fully depressed.

    添加评论

    • While holding the tabs down, slowly pivot the battery up.

    • The battery is now free and safe to pull out.

    添加评论

    • Unscrew three 2.4mm and one 5.7mm screws using a Phillips # 0.

    • Unscrew three 1.9mm screws in the battery compartment still using a Phillips # 0

    添加评论

    • Mind the wire connections on the bottom right side of the monitor. They are still connected between the monitor and computer.

    • Raise the monitor as you normally would until it pops out by itself. Rotate the left side up and to the right to unhook hinges that may catch on the computer.

    • Lay the monitor flat next to the computer.

    添加评论

    • Using a smaller spudger (like a PX3688), pivot the sound case out above the "F2" and "Insert" buttons.

    • Lift the case out and set it aside.

    • For the proceeding steps, put on your anti-static wrist strap and attach the metal clip to something metal and grounded in order to protect the delicate circuitry inside the computer.

    添加评论

    • Using the same spudger, pry the top of the keyboard up above the "F2" key.

    • Turn the computer so that the bottom is facing you.

    • The keyboard is connected to a black plastic strip, slowly pull the keyboard and place it to the side.

    添加评论

    • Disconnect the keyboard by gently pulling on the hard plastic square straight up from the white connector.

    添加评论

    • Remove four 2.4mm screws using the Phillips #0 screwdriver from each side of the audio speakers.

    • Note that the speaker with the white and black wires are on the left and the red and black wires are on the right.

    • Place the speakers to the side of the computer.

    添加评论

    • Use your fingers or a spudger to remove the white connector from its port.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Nicholas Ross

于2012年01月20日注册

155 信誉积分

创作了7篇指南

团队

Cal Poly, Team 10-31, Amido Winter 2012 Cal Poly, Team 10-31, Amido Winter 2012 的会员

CPSU-AMIDO-W12S10G31

5 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 7

总计 2,053