简介

The shutter button allows for the taking of pictures. This guide will explain how to get to and remove the shutter button and components that are associated with it.

Remove the screws from the bottom of the camera using the tri-wing screwdriver.
  • Remove the screws from the bottom of the camera using the tri-wing screwdriver.

    • Three 5.4 mm tri-head screws.

添加评论

Remove screws from charger side of camera using the Phillips 00 screwdriver.
  • Remove screws from charger side of camera using the Phillips 00 screwdriver.

    • Two 3.3 mm Phillips #00 screws.

添加评论

  • Remove screws from wrist-strap side of camera using the Phillips 00 screwdriver.

    • Two 3.3 mm Phillips #00 screws.

添加评论

  • Separate the front and back casing using the spudger.

  • Gently pull apart the two casings.

  • Pull the back casing away from the camera.

添加评论

  • Remove screws from the casing covering the LCD using the Phillips 00 screwdriver.

    • Remove the fifteen 2.9 mm Phillips #00 screws.

添加评论

  • Slide casing out using the spudger.

添加评论

  • Gently remove the LCD display data cable by gripping the end that is connected to the motherboard and pulling out.

添加评论

  • Pull on the shutter button display data cable on the end connected to the motherboard until it slides out.

添加评论

  • While slightly rotating the shutter button and data cable counter-clockwise, pull out until whole component comes out.

    • When inserting the new shutter button and data cable component, be sure it is placed properly into the camera or it will not function correctly.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Sarah Looper

于2013年03月11日注册

76 信誉积分

创作了7篇指南

团队

Clemson, Team 13-4, Benson Spring 2013 Clemson, Team 13-4, Benson Spring 2013 的会员

CLEM-BENSON-S13S13G4

2 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 4

总计 730