简介

This repair guide will show you how to replace the motherboard on a Fossil Q Marshal Gen 2 smartwatch. Be careful not to damage the motherboard, wiring, or the metal connectors on your smartwatch.

  1. Squeeze retaining pins together to release chain from watch body. This can be done by hand or with tweezers.
    • Squeeze retaining pins together to release chain from watch body. This can be done by hand or with tweezers.

    • Remove chain from opposing side of watch body.

    添加评论

  2. Use tweezers to grip the notches on the back cover, then unscrew the back cover (counter-clockwise) from the watch housing.
    • Use tweezers to grip the notches on the back cover, then unscrew the back cover (counter-clockwise) from the watch housing.

    • There is an actual tool made to remove this back cover, using the right tool may save you from scratching the back of watch with tweezers. The backcover tool can be purchased online, a local jeweler may also be willing to remove it for you.

    添加评论

    • Utilize tweezers or a spudger or your fingers to pull the black wire connector from the motherboard.

    • Utilize a spudger to pull the orange connector off of the motherboard.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Utilize tweezers to pull the white battery connector from the motherboard.

    添加评论

    • The internal electronics can now be pulled out of the watch as one unit leaving the screen remaining in the watch housing.

    • Taking the flat end of the spudger, pry it up.

    添加评论

    • The battery is secured to the back of the motherboard utilizing a sticky pad. Gently separate the battery from the board while making sure not to put too much stress on the board. This is best done at the location shown.

    添加评论

    • Remove battery from plastic housing.

    • Slip wires through large slot in plastic housing to completely remove.

    添加评论

    • Using your finger remove the metal hooks from the black electronic housing.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Matthew Tucker

于2017年11月07日注册

373 信誉积分

创作了3篇指南

团队

IUPUI, Team S2-G5, Harley Fall 2017 IUPUI, Team S2-G5, Harley Fall 2017 的会员

IUPUI-HARLEY-F17S2G5

3 名成员

创作了4篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 16

过去的30天: 37

总计 490