简介

When fishing, it is very easy for a bigger catch to over power the fisher and break their line. This guide serves to show how one can restring a fishing line after it has been snapped. The only special requirement this guide needs is that the spool must still be intact and functioning correctly.

工具

无需工具。

  1. Thread fishing line through all eyelets on the fishing pole.
    • Thread fishing line through all eyelets on the fishing pole.

    添加评论

  2. At the top of the allotted seven to ten feet, thread the line through one hook of the bobber by depressing the opposite side of the bobber so that the hook is exposed.
    • At the top of the allotted seven to ten feet, thread the line through one hook of the bobber by depressing the opposite side of the bobber so that the hook is exposed.

    添加评论

    • Repeat step two for the opposite end of the bobber, threading the line through the second hook.

    添加评论

    • About one to two feet before the end of the line, thread a weight onto the line.

    添加评论

    • Tie a knot around the weight's eyelet. (No specific knot needed, it just needs to stay in place.)

    添加评论

    • At the very end of the line, thread the line through the eyelet of the lure about 6 inches.

    添加评论

    • Twist the line around itself approximately five to six times.

    添加评论

    • Thread the remaining line through the hole created by the previous step near the lure eyelet.

    添加评论

    • Pull the knot tight.

    添加评论

结论

After step 9 you are ready to fish.

Trevone Martin

于2018年02月22日注册

169 信誉积分

撰写一个指南

This is Joe from Durban Deep Sea Fishing Charters. This is a short and concise but very helpful guide to replace a fishing line. I will be sure to share this with my clients. Thanks guys

Joe Osborne - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 41