简介

If the speaker is dead or blown, install a new one.

  1. Be sure to unplug the device before proceeding.
    • Be sure to unplug the device before proceeding.

    • Use a Phillips #0 screwdriver to remove the four 21.7mm screws holding the back panel to the frame.

  2. Once the screws are out, use a plastic opening tool or spudger to pry the top of the back panel open. There may be some resistance, but it will eventually pry loose.
    • Once the screws are out, use a plastic opening tool or spudger to pry the top of the back panel open. There may be some resistance, but it will eventually pry loose.

  3. Once the top is separated, use your hand to remove the back panel from the unit.
    • Once the top is separated, use your hand to remove the back panel from the unit.

  4. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店

    善于维修,即天赋异禀。

    与 #ImAGenius 分享您的维修故事

    我们都是天才

    与 #ImAGenius 分享您的维修故事

  5. Using tape or a post-it, label the input and output wires on the reverb. Remove these wires from the box.
    • Using tape or a post-it, label the input and output wires on the reverb. Remove these wires from the box.

  6. Remove the two female connection terminals from the speaker terminals.
    • Remove the two female connection terminals from the speaker terminals.

  7. Use a Philips #1 screwdriver to remove the four 21.9 mm Phillips screws from the perimeter of the speaker.
    • Use a Philips #1 screwdriver to remove the four 21.9 mm Phillips screws from the perimeter of the speaker.

  8. Gently remove the speaker. Gently remove the speaker.
    • Gently remove the speaker.

结论

To install the new speaker, follow the instructions given in reverse.

Stephen Figueira

于2012年10月04日注册

104 信誉积分

创作了3篇指南

团队

Cal Poly, Team 24-30, Regan Fall 2012 Cal Poly, Team 24-30, Regan Fall 2012 的会员

CPSU-REGAN-F12S24G30

5 名成员

创作了7篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 11

过去的30天: 50

总计 5,718