跳转到主内容

Eureka 1660SP Pole Extender Button Spring Replacement

你所需要的

  1. Eureka 1660SP Pole Extender Button Spring Replacement, Motor Housing: 步骤 1 中的图像 1,2 Eureka 1660SP Pole Extender Button Spring Replacement, Motor Housing: 步骤 1 中的图像 2,2
    • Before you start, make sure your vacuum is unplugged the power outlet.

    • Press and hold down the black button below the handle while pulling the pole out.

  2. Eureka 1660SP Pole Extender Button Spring Replacement: 步骤 2 中的图像 1,2 Eureka 1660SP Pole Extender Button Spring Replacement: 步骤 2 中的图像 2,2
    • Press the black separator switch to separate the top and bottom halves of the vacuum.

  3. Eureka 1660SP Pole Extender Button Spring Replacement: 步骤 3 中的图像 1,3 Eureka 1660SP Pole Extender Button Spring Replacement: 步骤 3 中的图像 2,3 Eureka 1660SP Pole Extender Button Spring Replacement: 步骤 3 中的图像 3,3
    • Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.

    • Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.

    • Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

  4. Eureka 1660SP Pole Extender Button Spring Replacement, Pole Extender Button Spring: 步骤 4 中的图像 1,1
    • Pull out the button and the spring attached to it.

    • Swap the old spring with a new one.

  5. Eureka 1660SP Pole Extender Button Spring Replacement: 步骤 5 中的图像 1,1
    • Insert the new spring and button back into the right slot as shown in the picture.

结论

To reassemble your device, follow these instructions in reverse order.

团队

UMass Dartmouth, Team 1-1, Gulbrandsen Fall 2013 UMass Dartmouth, Team 1-1, Gulbrandsen Fall 2013 的会员

UMASSD-GULBRANDSEN-F13S1G1

3 名成员

创作了12篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时: 0

过去 7 天: 1

过去 30 天: 2

总计 302