配件

无需配件。

  1. Make sure that your vacuum is unplugged from a power source. Press the black button just below the handle and extend the pole fully.
    • Make sure that your vacuum is unplugged from a power source.

    • Press the black button just below the handle and extend the pole fully.

  2. Press the black separator switch to separate the top and bottom halves of the vacuum. Press the black separator switch to separate the top and bottom halves of the vacuum.
    • Press the black separator switch to separate the top and bottom halves of the vacuum.

  3. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  4. Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown. Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing. Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.
    • Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.

    • Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.

      • Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

  5. Pull out the button and the spring attached to it.
    • Pull out the button and the spring attached to it.

    • Swap the old spring with a new one.

  6. Insert the new spring and button back into the right slot as shown in the picture.
    • Insert the new spring and button back into the right slot as shown in the picture.

结论

To reassemble your device, follow these instructions in reverse order.

Nikhila Vijaybhaskar

于2013年09月24日注册

224 信誉积分

创作了2篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 2

总计 195