跳转到主内容

Eton FRX3 Case Assembly Replacement

仅作为前提条件
本指南仅用作其他指南的先决条件。不能单独食用。

你所需要的

  1. Eton FRX3 Case Assembly Replacement, Rechargeable Battery Pack: 步骤 1 中的图像 1,1
    • Pull the plastic tab on the battery compartment cover panel to loosen it, then pull the panel off.

  2. Eton FRX3 Case Assembly Replacement: 步骤 2 中的图像 1,1
    • Disconnect the battery pack wires from the device and remove the battery pack.

  3. Eton FRX3 Case Assembly Replacement, Case Assembly: 步骤 3 中的图像 1,1
    • Use the T10 hexagonal tip from the iFixit Bit Driver Kit or comparable tool to remove the two 22 mm hexagonal screws on the front face of the device.

  4. Eton FRX3 Case Assembly Replacement: 步骤 4 中的图像 1,1
    • Remove the two 22 mm hexagonal screws on the upper rear of the device.

  5. Eton FRX3 Case Assembly Replacement: 步骤 5 中的图像 1,1
    • Use a long, slender screwdriver to reach and remove the two 10 mm Phillips #00 screws recessed deep in the body of the device.

    • If you're using the 54-bit toolkit, the female hexagonal bit can be used to extend the reach of the Phillips #00 bit.

  6. Eton FRX3 Case Assembly Replacement: 步骤 6 中的图像 1,1
    • On the bottom of the device are two rubber feet. Using the blue plastic opening tool, pry them up and pull straight off.

    • It’s best to place these on their non-sticky side while you work, as you’ll want them to keep as much tackiness as possible for reassembly.

  7. Eton FRX3 Case Assembly Replacement: 步骤 7 中的图像 1,1
    • Pull apart the two halves of the device at the seam.

    • Three components from the back half will prevent you from fully opening the device, just unplug these connections as shown in the image.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Kenneth Sills

于02/10/16注册

762 声望

创作了6篇指南

团队

USF Tampa, Team 1-6, Nance Spring 2016 USF Tampa, Team 1-6, Nance Spring 2016 的会员

USFT-NANCE-S16S1G6

4 名成员

创作了13篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 0

总计 59