Etekcity Lasergrip 1080 Trigger Replacement

简介

This guide will show you how to repair a trigger that has a faulty connection. If the trigger will depress and not return to its original position or if it will not even depress, this will be necessary. The tool needed is a screwdriver. There are no hazards in this guide.

你所需要的

步骤 1 Battery

Etekcity Lasergrip 1080 Trigger Replacement, Battery: 步骤 1 中的图像 1，1

Pull the battery cover away from the handle by gripping near the thumb groove.

编辑

步骤 2

Gently pull the battery out of the handle.
Excessive force could damage wires.

编辑

步骤 3

Disconnect the battery by pulling the connector away from it.
Positive first
Negative second
When replacing the battery, this order is reversed.

编辑

步骤 4 Buttons

Etekcity Lasergrip 1080 Trigger Replacement, Buttons: 步骤 4 中的图像 1，2

Etekcity Lasergrip 1080 Trigger Replacement, Buttons: 步骤 4 中的图像 2，2

Remove the battery cover from the device by pulling it straight out.

编辑

步骤 5

Using the plastic opening tool remove the front and rear yellow covers.
When removing the back cover, be careful not to lose the buttons as they are not connected.

编辑

步骤 6

Remove the two 3.1 mm Phillips #0 screws.

编辑

步骤 7

Pull the two halves apart.
Be careful not to lose any components on the inside.

编辑

步骤 8

Realign the buttons with the button terminals.
Red terminal to red button.
Orange terminal to orange button.
Yellow terminal to yellow button.

编辑

步骤 9 Etekcity Lasergrip 1080 Trigger Replacement

Etekcity Lasergrip 1080 Trigger Replacement, Etekcity Lasergrip 1080 Trigger Replacement: 步骤 9 中的图像 1，2

Etekcity Lasergrip 1080 Trigger Replacement, Etekcity Lasergrip 1080 Trigger Replacement: 步骤 9 中的图像 2，2

Carefully pull the trigger out.
The trigger is spring loaded, so be careful that you do not lose the spring as you pull the trigger out.
To put the trigger back in, align the peg with the hole in the handle and align the shaft with the button terminal.