Enabot EBO SE Lower Housing Replacement

简介

The lower housing is very important to your Enabot EBO SE since this is where the daughterboard, battery, and speaker are located. You will potentially need to replace them for your Enabot EBO SE to continue functioning correctly. We will take you step by step to replace these necessities and hopefully help you have a more pleasant experience.

你所需要的

步骤 1 Wheel Assembly

Enabot EBO SE Lower Housing Replacement, Wheel Assembly: 步骤 1 中的图像 1，1

Gently turn the robot upside down.
Place the robot on a stable surface to prevent it from rolling or falling.

翻译

步骤 2

Enabot EBO SE Lower Housing Replacement: 步骤 2 中的图像 3，3

Use a flathead 2.5 mm screwdriver to remove the 5.7 mm screw from the wheels.
A tool should have been provided in the box for this purpose.

翻译

步骤 3

Pull the wheel assembly towards you so it comes straight off without resistance.
If there is resistance, make sure to apply gentle force when pulling as it can get damaged with too much force.

翻译

步骤 4 Lower Housing

Enabot EBO SE Lower Housing Replacement, Lower Housing: 步骤 4 中的图像 1，2

Enabot EBO SE Lower Housing Replacement, Lower Housing: 步骤 4 中的图像 2，2

Use a Torx screwdriver to remove the four 9 mm screws from the assembly.

翻译

步骤 5

Enabot EBO SE Lower Housing Replacement: 步骤 5 中的图像 3，3

Use your fingernail to carefully press down and eject the Micro SD Card from the back of the Enabot.
Keep the Micro SD Card in a safe spot for later.

翻译

步骤 6

Place the iFixit opening tool inside the Micro SD slot.
Very carefully apply pressure to the top of the slot and pry open the casing to separate the upper and lower housing.

翻译

步骤 7

Enabot EBO SE Lower Housing Replacement: 步骤 7 中的图像 3，3

Using the iFixit opening tool or your fingernail, place it underneath the gray tab on the lower housing.
Lift the tab up and pull out the ribbon cable to disconnect it from the lower housing.

翻译

步骤 8

Enabot EBO SE Lower Housing Replacement: 步骤 8 中的图像 3，3

There are two black and red wire connectors attached to the upper and lower housing.
Gently use your finger nails to lift up and disconnect both wires to fully separate the upper and lower housings.

翻译