跳转到主内容

简介

Often, through expected usage, an analog stick may become dislodged or misaligned on the DualShock 2 Wireless controller. This guide will show how to remove the faulty stick and realign it.

  1. Remove the battery cover by pressing down on the release tab. Remove the batteries.
    • Remove the battery cover by pressing down on the release tab.

    • Remove the batteries.

    • It may be useful to use a small object to prop the controller during this fix.

    • For your safety and for the safety of the device, never work on the controller while it is still powered.

  2. Remove the six 7.8 mm anchoring screws from the back casing of the controller using a Phillips #0 screwdriver. Remove the six 7.8 mm anchoring screws from the back casing of the controller using a Phillips #0 screwdriver.
    • Remove the six 7.8 mm anchoring screws from the back casing of the controller using a Phillips #0 screwdriver.

  3. Pull apart the outer casing by hand, or by using a plastic opening tool, from the bottom of the controller. Be mindful not to sever the connection between the battery pack attached to the back casing and the internal board
    • Pull apart the outer casing by hand, or by using a plastic opening tool, from the bottom of the controller.

    • Be mindful not to sever the connection between the battery pack attached to the back casing and the internal board

  4. Remove the two 6.1 mm screws holding the internal analog stick board and the front of the controller together. Remove the two 6.1 mm screws holding the internal analog stick board and the front of the controller together.
    • Remove the two 6.1 mm screws holding the internal analog stick board and the front of the controller together.

  5. Lift the analog stick board away from the front of the controller. Remove the detached or loose analog stick for realignment.
    • Lift the analog stick board away from the front of the controller.

    • Remove the detached or loose analog stick for realignment.

  6. Realign the analog stick by pushing the removed stick back into its chassis with focus on pushing it in at the new, desired resting angle. You should feel or hear a small click if done correctly.
    • Realign the analog stick by pushing the removed stick back into its chassis with focus on pushing it in at the new, desired resting angle. You should feel or hear a small click if done correctly.

    • The stick may not immediately click into place under the pressure. Instead of pushing harder, try rotating the stick 90 degrees and pushing down again.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Roger Campbell

于2017年07月12日注册

125 信誉积分

撰写一个指南

团队

Texas Tech, Team S1-G1, Rauch Summer 2017 Texas Tech, Team S1-G1, Rauch Summer 2017 的会员

TTU-RAUCH-SU17S1G1

2 名成员

创作了1篇指南

添加评论

浏览统计数据:

过去的24小时: 3

过去的7天: 28

过去的30天: 102

总计 988