跳转到主内容

修复你的物品

维修的权力

商店

简介

Most toilet repairs are easier to perform without water in the toilet tank. Use this guide to drain the tank of a traditional gravity flush toilet.

  1. Lift the tank lid up and away from the toilet tank. Lift the tank lid up and away from the toilet tank. Lift the tank lid up and away from the toilet tank.
    • Lift the tank lid up and away from the toilet tank.

  2. 打开所有标签

    Mac的RAM升级套装

    购买套装

    所有选项卡都有足够的 RAM

    购买套装
  3. Shut off the stop valve underneath the toilet by turning it clockwise until it becomes tight. The appearance of this valve may differ from toilet to toilet, but most operate the same.
    • Shut off the stop valve underneath the toilet by turning it clockwise until it becomes tight.

    • The appearance of this valve may differ from toilet to toilet, but most operate the same.

  4. Push down the flush lever. Hold the lever down until water stops draining from the tank.
    • Push down the flush lever.

    • Hold the lever down until water stops draining from the tank.

    • A small amount of water will remain in the bottom of the tank.

    • If the flush lever or pull chain have become disconnected, lift up the toilet flapper to drain the tank.

结论

Most toilets retain a small amount of water in the tank after draining. To remove any excess water from the bottom of your toilet tank, use our guide for Sponge Drying a Toilet Tank.

另外一个人完成了本指南。

Ron Davis

于2015年02月17日注册

25,251 信誉积分

创作了13篇指南

I have a cracking in my toilet tank going almost the length of the tank and below water line resulting in a leak. In your experience is a sealant a good option or in reality would the tank need to be replaced in time ?

Thanks

K EVANS - 回复

It would make more sense to replace the tank, than seal any crack which would only reappear after time anyway.

John Turner -

添加评论

浏览统计数据:

过去的24小时: 5

过去的7天: 28

过去的30天: 228

总计 22,066