简介

You should have a basic understanding of tool usage (ie. screwdrivers)

Remove the face plate by depressing the small plastic tab
  • Remove the face plate by depressing the small plastic tab

    • *NOTE: eject disk tray first before dis-assembly to gain access.

For my BDP-S185, there was a steel wire spring running through both the face plate and tray that came dislodged. I could not put it back in place, and two plastic tabs on the face plate broke. More detailed pictures of this step and the fine parts involved in the face plate to disk tray latching mechanism would be useful.

Tom Roden - 回复

Release front 4 tabs in order to slide main cover forward.
  • Release front 4 tabs in order to slide main cover forward.

    • *NOTE: slide only a few mils forwards before next step.

添加评论

  • Release tabs on both left and right sides of unit while maintaining forward pressure to slide cover off.

    • *NOTE: The arrows depict where the tabs are located.

hi team 7…..

you don’t suggest a way to release the tabs weather it’s in or out….

you emphasis on the removing the cover delayed the importance getting at the release tabs

peter - 回复

  • After cover removal, you should now have access to the internal components.

  • We will begin removing the power supply. Compress the center clip and open plastic shield.

添加评论

  • Release clip to remove 6 pin power cable.

添加评论

  • Unscrew two mounting screw for power supply. Slide forward and pull out for removal.

添加评论

  • This should be your current progress thus far.

添加评论

  • Release tab to remove plastic power supply shield.

添加评论

  • Remove the three screws.

  • Now depress metal tab to fully remove heat sink clamp.

添加评论

  • Pull on indicated ribbon cable to begin removal of front display.

  • Now remove single screw to remove front display panel.

添加评论

  • This should be you current dis-assembly progress thus far.

添加评论

  • Next, remove all three ribbon cables attached to optical disc drive.

    • *NOTE: largest ribbon cable has small secure clamp, be sure to release it before pulling.

  • Now unscrew both mounting screw for optical disc drive for complete removal.

添加评论

  • To completely remove the main board, locate screws on back of unit. Unscrew these 2 screws and then slide main board out.

添加评论

  • You should now be completely dis-assembled. For further dis-assembly of the optical disc drive, continue to step 15.

添加评论

  • First remove metal shroud exposing tabs.

  • Peel back security tape and release all 4 tabs (2 on each side) for removal of top cover.

  • Now the internal components of the optical disc drive are now exposed.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

TEAM 7

于2013年04月01日注册

281 信誉积分

撰写一个指南

Hi! I have just a quick question! The front display panel of my Sony Blu Ray player had broken! The small board with the USB mounted onto it, remote sensor and buttons! What is the name of this board? I was looking to order a replacement

earlovann - 回复

Nice info. Need to know how to get replacement bluray player. Any ideas? Do not want to buy new TV yet.

Keith - 回复

now I know I'm missing lots of parts...lol

Tina Marie - 回复

添加评论

浏览统计数据:

过去的24小时: 4

过去的7天: 25

过去的30天: 138

总计 9,883