1. Using the Phillips #0 in the bit driver, carefully loosen and remove the single  5mm screw.
    • Using the Phillips #0 in the bit driver, carefully loosen and remove the single 5mm screw.

    • With the retaining screw removed, lift the panel upwards to separate it from the netbook.

    添加评论

  2. To replace the panel, do step 1 in reverse:
    • To replace the panel, do step 1 in reverse:

      • Align the panel slots in the appropriate grooves and set in place.

      • With the bit driver, replace the screw to secure the RAM panel.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Using the bit driver and the Phillips bit, remove both of the panel's retaining screws.

    • With the screws removed, lift the panel in the designated direction, as depicted in photo, for removal.

    • The hard drive is located beneath this cover and is now accessible.

    添加评论

    • To replace the hard drive panel, do step 3 in reverse:

      • Place the panel back in its original position and press down.

      • If the hard drive was removed or replaced during this process, improper installation may prevent the hard drive panel from sitting in the slots properly.

      • With the bit driver and Phillips bit, replace the two retaining screws to secure the cover plate in place.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Mason McCaskill

于2013年10月18日注册

943 信誉积分

创作了9篇指南

团队

Clemson, Team 14-2, Benson Fall 2013 Clemson, Team 14-2, Benson Fall 2013 的会员

CLEM-BENSON-F13S14G2

3 名成员

创作了9篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 7

总计 598