简介

Before the display and camera housing can be repaired or replaced they must first be separated. This guide will detail how to prepare the display and camera for separation.

配件

无需配件。

Begin by placing the camera upside down and removing the three small center screws.
  • Begin by placing the camera upside down and removing the three small center screws.

  • All screws are the same size and length and can be used interchangably.

添加评论

Turn the camera on its side (Counterclockwise). Remove the two small screws on either side of the silver panel.
  • Turn the camera on its side (Counterclockwise). Remove the two small screws on either side of the silver panel.

  • Turn the camera 180 degrees onto its other side and remove the two small screws on either side of the silver panel.

添加评论

  • Locate the camera's tripod mount located on the bottom of the camera.

  • Carefully remove the camera's tripod mount and place it aside.

  • Be careful not to lose this piece.

  • Rotate the silver panel labeled 4x clockwise.

添加评论

  • Align the camera so that the side with "4x Optical Zoom" is facing toward you.

  • Gently twist the bottom corner clockwise until you feel the side panel unlock.

  • Lift off the side panel and set aside.

添加评论

  • Rotate the camera 180 degrees to face the side panel with the lanyard loop on it.

  • Gently lift the panel vertically until it lifts off

  • Take care to not lose the small rectangular portion on the bottom of the panel.

添加评论

  • Position the camera so the bottom is facing up and the display away from the surface.

  • Gently pry the screen portion from the camera portion with your fingers or a plastic prybar.

  • Do not fully separate the two components! the screen is attached by two ribbon cables.

  • Lay the display flat to expose the circuit board and the display control ribbon cables.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Steve Van Hall

于2012年03月09日注册

27 信誉积分

创作了2篇指南

团队

Clemson, Team 2-3, Benson Spring 2012 Clemson, Team 2-3, Benson Spring 2012 的会员

CLEM-BENSON-S12S2G3

3 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 1,397