配件

无需配件。

  1. Remove the battery (which also functions as the back cover) from the device. This step is not explicitly shown, but a picture without the battery cover shows the device post-battery removal.
    • Remove the battery (which also functions as the back cover) from the device. This step is not explicitly shown, but a picture without the battery cover shows the device post-battery removal.

    添加评论

  2. Use a Philip's head screw driver to remove the screws from the case.
    • Use a Philip's head screw driver to remove the screws from the case.

    • Place the screws in a small container to avoid losing them.

    添加评论

    • Remove the front cover.

      • First, insert a small pry bar where the black front cover and white back cover meet.

      • Begin prying the black plastic up, slowing moving around to the bottom and other side.

      • At an angle, carefully pull up on the front cover separate the two pieces.

    • Excellent! Now you have removed the front cover!

    添加评论

    • While looking down at the device, place your index finger at the top of the circuit board and your thumb on the device screen.

    添加评论

    • Using your fingers, gently pull the top of the circuit board up toward you while also sliding the bottom of the circuit board away from the bottom of the Sirius Stiletto 100 back cover.

    添加评论

    • Congratulations! You have successfully removed the internal circuit board from the Sirius Stiletto 100 back cover.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Staten

于2012年03月09日注册

69 信誉积分

撰写一个指南

团队

Clemson, Team 2-1, Benson Spring 2012 Clemson, Team 2-1, Benson Spring 2012 的会员

CLEM-BENSON-S12S2G1

3 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 4

总计 1,729