配件

无需配件。

  1. Locate the battery cover on the bottom of the camera.
    • Locate the battery cover on the bottom of the camera.

    添加评论

  2. Place your thumb on the battery cover and push towards the arrow. The cover will release and pop open.
    • Place your thumb on the battery cover and push towards the arrow. The cover will release and pop open.

    添加评论

    • Remove the batteries from the camera.

    添加评论

    • Unscrew and remove four (3mm) screws on the right side of the camera. This will release the front and back casings.

    添加评论

    • Use your nail or a flat object to pry up the edge of the front casing. Push the casing up and back.

    • Repeat this step for the back casing.

    添加评论

    • Locate the black plastic strip under the screen above the white plastic strip.

    添加评论

    • Pull up both sides of the black piece up about a mm.

    • The black plastic piece is not meant to come all the way off, just enough to release the screen.

    • Once the piece is lifted carefully slide the screen out of the slot.

    添加评论

    • Unscrew and remove the four (6 mm) screws on the inside casing.

    添加评论

    • Pull the inner casing off of the camera.

    添加评论

    • Unscrew and remove the four (4mm) screws from the logic board.

    添加评论

    • Use a spudger to pry up all four sides of the logic board and slide it out of the camera.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Dani

于2010年06月24日注册

21 信誉积分

创作了7篇指南

团队

Cal Poly, Team 3-3, Johann Summer 2010 Cal Poly, Team 3-3, Johann Summer 2010 的会员

CPSU-JOHANN-R10S3G3

2 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 1

总计 794