跳转到主内容

简介

This guide will show you how to separate the body into the trigger frame and the bolt frame. This will allow you to access the solenoid and eyes.

配件

没有特定配件。

  1. Remove the four screws from the grip with the 5/64" allen wrench. There are two on each side. Remove the four screws from the grip with the 5/64" allen wrench. There are two on each side.
    • Remove the four screws from the grip with the 5/64" allen wrench. There are two on each side.

  2. Pull the grip away from the frame. Pull the grip away from the frame.
    • Pull the grip away from the frame.

  3. Pull the grip through the opening. The grip is connected in the middle and is one piece.
    • Pull the grip through the opening.

    • The grip is connected in the middle and is one piece.

  4. PC 笔记本电池

    An easy fix for a big power boost.

    现在开始购物

    PC 笔记本电池

    An easy fix for a big power boost.

    现在开始购物
  5. Remove the macroline from the fitting by pulling the metal ring around the end of the fitting away while pulling out the macroline. It helps to rotate the collar to create room to pull out macroline. It helps to rotate the collar to create room to pull out macroline.
    • Remove the macroline from the fitting by pulling the metal ring around the end of the fitting away while pulling out the macroline.

    • It helps to rotate the collar to create room to pull out macroline.

  6. While pulling in the metal ring on the fitting, pull the macroline out. While pulling in the metal ring on the fitting, pull the macroline out. While pulling in the metal ring on the fitting, pull the macroline out.
    • While pulling in the metal ring on the fitting, pull the macroline out.

  7. Use 1/8" allen wrench to remove screw behind regulator. Use 1/8" allen wrench to remove screw behind regulator. Use 1/8" allen wrench to remove screw behind regulator.
    • Use 1/8" allen wrench to remove screw behind regulator.

  8. Use 1/8" allen wrench to loosen the screw inside the grip on the right side. The screw only needs to be turned a couple of times. Slide the upper frame forward on the rails and remove the screw from the slot to separate the two halves of the body.
    • Use 1/8" allen wrench to loosen the screw inside the grip on the right side.

    • The screw only needs to be turned a couple of times.

    • Slide the upper frame forward on the rails and remove the screw from the slot to separate the two halves of the body.

    • BE CAREFUL: Do not pull the two frames apart too much or too quickly. This may cause the wires to be damaged.

结论

To reassemble your device, follow these instructions in reverse order.

Rett Triplett

于2013年10月18日注册

801 信誉积分

创作了8篇指南

团队

Clemson, Team 13-6, Benson Fall 2013 Clemson, Team 13-6, Benson Fall 2013 的会员

CLEM-BENSON-F13S13G6

3 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 4

总计 470