跳转到主内容

简介

Since this is step one, you will just need to start with your camera.

配件

没有特定配件。

  1. Remove the battery and memory card from the device.
    • Remove the battery and memory card from the device.

  2. Remove 4 screws from the right side of the camera.
    • Remove 4 screws from the right side of the camera.

    • There are two 3.4mm screws at the top.

    • There are two 2.2mm screws at the bottom.

  3. Remove the single 3.4mm screw on the left side of the camera.
    • Remove the single 3.4mm screw on the left side of the camera.

  4. iPhone 电池维修工具包

    只要 $29.99

    Buy Now

    iPhone 电池维修工具包

    只要 $29.99

    Buy Now
  5. Remove 5 screws from the base of the camera.
    • Remove 5 screws from the base of the camera.

    • There are two 2.2mm screws next to the battery compartment.

    • There are three 4mm screws around the tripod mount.

  6. Slowly slide the back cover away from the device
    • Slowly slide the back cover away from the device

    • The back casing is held in place by two ribbon cables. Do not pull the back cover too far from the camera.

  7. Detach both ribbon cables using a spudger. Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.
    • Detach both ribbon cables using a spudger.

    • Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.

  8. Remove the back casing from the camera.
    • Remove the back casing from the camera.

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

Ben Canfield

于2010年10月10日注册

403 信誉积分

创作了3篇指南

团队

Cal Poly, Team 9-21, Regan Fall 2010 Cal Poly, Team 9-21, Regan Fall 2010 的会员

CPSU-REGAN-F10S9G21

4 名成员

创作了7篇指南

That is not a disassembly! All is shows is taking the back of the camera off. How about showing how to disassembly the camera down to its individual components and make repairs, like getting the lens to extend of fixing a sticking shutter.

JR Tan - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 12

总计 6,150