配件

无需配件。

Unscrew the bottom and right side panel screws using a #00 screwdriver. (5 screws)
  • Unscrew the bottom and right side panel screws using a #00 screwdriver. (5 screws)

Put a notice on here that the screws are very small and are easy to misplace while disassembling device. Also, while disassembling the device there was only one screw present, where the guide suggested there were three.

Curtis Reedy - 回复

Before beginning, put a note that the camera should be turned off before proceeding.

Curtis Reedy - 回复

Add a note at the beginning of the guide that there are a large number of small screws that should be separated as the steps are completed.

Curtis Reedy - 回复

There's a capacitor .....watch out for it in every step.

BILL BOYD - 回复

Remove the right side panel by pulling off the large silver piece.
  • Remove the right side panel by pulling off the large silver piece.

There is no reference to removing screws from the right side panel, where it is necessary to remove 2 screws to do so.

Curtis Reedy - 回复

  • Unscrew the remaining side and front panel screws using a #00 screwdriver. (3 screws)

添加评论

  • Using your thumb and forefinger, pull off the silver name plate and silver "T-shape" piece. (2 pieces)

添加评论

  • Remove the black front panel by sliding it towards the lens and then pulling it up off the camera.

添加评论

  • Remove 3 screws from the front of the camera using a #00 screwdriver.

  • Lift the two tabs to separate the case using a spudger. (one tab on top and one tab on the right side)

Wrong point of focus for the second picture. What should be in focus is very blurry.

Curtis Reedy - 回复

  • Using a plastic spudger, lift up the black clips.

  • Still using the plastic spudger, detach the gold connector strip and white connector strip.

  • Using both hands, pull the camera apart into two pieces.

There were multiple gold strips, so the one that needs to be pulled should be highlited in the picture.

Curtis Reedy - 回复

in step seven pull up the black bar of the ZIF connectors before pulling out the white or gold ribbons

Curtis Reedy - 回复

  • Using a plastic spudger, lift up the black clips.

  • Still using the spudger, detach the 3 gold wire tape connectors from the inside of the camera.

添加评论

  • Remove 3 screws from the inside of the camera using a #00 screwdriver.

添加评论

  • Using your thumb and forefinger, pull the lens piece straight out from the body of the camera.

添加评论

  • Unscrew two screws on the right side of the camera using a #00 screwdriver.

添加评论

  • Using a plastic spudger, lift up the black clips.

  • Still using the spudger, detach the gold wire tape connectors from the logic board.

添加评论

  • Unsolder the upper right and lower left wires to remove logic board.

添加评论

  • In order to remove the logic board, grab each side of it and pull up using your thumb and forefinger.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Max McIntyre

于2011年01月21日注册

511 信誉积分

创作了4篇指南

团队

Cal Poly, Team 13-4, Forte Winter 2011 Cal Poly, Team 13-4, Forte Winter 2011 的会员

CPSU-FORTE-W11S13G4

6 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 1

过去的30天: 4

总计 2,691