简介

This guide is a step by step procedure to disassemble the base of the phone. It is the preliminary step in gaining access to the inner components of the Nokia 2366i.

  1. Turn off the phone.
    • Turn off the phone.

    • Position the phone so that the back side is in view.

    添加评论

  2. Apply pressure on the cover while simultaneously sliding the cover downward.
    • Apply pressure on the cover while simultaneously sliding the cover downward.

    • Remove the back battery cover.

    添加评论

    • Insert the spudger between the base of the phone and the phone battery.

    • Position the phone so that the battery won't fall out of the phone.

    • Carefully lift the battery out of the phone.

      • The battery lifts out of the phone easily.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use a Phillips #00 screwdriver or your fingers to remove the rubber tabs at top back of the phone.

    添加评论

    • Remove four 5mm screws from the back of the phone using a T6 Torx screwdriver:

      • 2 screws at the bottom

      • 2 screws at the top

    添加评论

    • Rotate the phone clockwise so the edge is facing you.

    • Insert the spudger in tabs between the outer casing and the inside frame.

    • Slide the spudger upwards.

      • This will remove the rear case of the phone.

    添加评论

    • The phone should now be in two different sections.

      • 1) The rear case of the phone.

      • 2) The motherboard and the rest of the phone.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Jonathan Newman

于2011年01月21日注册

486 信誉积分

创作了4篇指南

团队

Cal Poly, Team 1-14, Amido Winter 2011 Cal Poly, Team 1-14, Amido Winter 2011 的会员

CPSU-AMIDO-W11S1G14

5 名成员

创作了16篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 1,434