简介

The speaker is attached to the circuit board with two wires and is glued onto the front case. After the speaker is removed the new speaker will need to be re-glued and re-soldered into place.

First, apply pressure with your thumb on the top of the battery cover.
  • First, apply pressure with your thumb on the top of the battery cover.

添加评论

Next, pull down on the cover until it begins to slide.
  • Next, pull down on the cover until it begins to slide.

添加评论

  • Finally, once the cover is completely off, pry up the old batteries with your finger or a strong, skinny tool (i.e. spudger).

添加评论

  • Unscrew the six 8.0 millimeter long, #0 screws on the backside of the case using the Phillips #0 screwdriver.

添加评论

  • Detach back part of the case by gently lifting up.

添加评论

  • Remove the circuit board from the front part of the radio case.

  • Clip the red and black connecting wires at the base closest to the circuit bored in the spots denoted by the two red circles.

添加评论

  • Scrape off the glue on the outer lining of the speaker using the metal spudger.

添加评论

  • Pry the speaker from the case using the metal spudger.

  • This should not take excessive force, so make sure all remaining glue is scraped off from the edges if it will not easily come out.

添加评论

  • The speaker is now disassembled!

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

James Tucker Dunn

于2013年01月18日注册

371 信誉积分

创作了6篇指南

团队

Cal Poly, Team 19-43, Regan Winter 2013 Cal Poly, Team 19-43, Regan Winter 2013 的会员

CPSU-REGAN-W13S19G43

3 名成员

创作了9篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 2

总计 399