跳转到主内容

Disassembling LeapPad Explorer Tablet Interior Soldered Wire Connections

你所需要的

  1. Disassembling LeapPad Explorer Tablet Interior Soldered Wire Connections, Interior Soldered Wire Connections: 步骤 1 中的图像 1,1
    • The back panel (pictured left) has a black wire (end of wire circled red). The wire solders to the bottom right corner of the card drive.

    • The front panel (pictured right) has a black and red wire (end of wired circled green). This wire solders to a small circular spot next to where the black wire connects to the back (from above).

结论

To reassemble your device, follow these instructions in reverse order.

ewkpates

于05/03/12注册

133 声望

撰写一个指南

2条评论

To open the leappad top start with, remove battery covers and the 6 screws.

The two halves slide, bottom half towards cartridge slot, to make it harder they have used double sided tape on the bottom platic tounges, so a scredriver in the bottom will be needed to prize the slide.

Lawrence - 回复

Good stuff. I'm trying to slide the back plate upward, but to no avail. You mentioned tape. Where exactly is it located?

John - 回复

添加评论

浏览统计数据:

过去 24 小时: 0

过去 7 天: 1

过去 30 天: 6

总计 5,934