Turn off the camera.
  • Turn off the camera.

    • Locate the power switch on the front of the camera below the camera lens.

    • Slide the switch to the off position.

添加评论

Locate the 3 screws that hold the back cover to the camera.
  • Locate the 3 screws that hold the back cover to the camera.

    • One screw is located on the film opener side of the camera.

    • The other screws are located on the opposite side of the camera.

添加评论

  • Use the Phillips #00 Precision Screwdriver and remove the screws on the back cover.

添加评论

  • Open the film door to remove the back cover.

    • Slide the film door lever to the left until the film door opens.

添加评论

  • Use a plastic opening tool to pry the case open until a small gap is present.

    • Repeat this process at the top and bottom of the film door to loosen it.

添加评论

  • Grab the top and bottom of the case firmly as shown.

    • Gently remove the back of the camera case with a slight twisting motion.

添加评论

  • Locate the 3 screws on the camera that hold the front cover of the camera to the camera body.

    • The first 2 are located on the bottom of the camera.

    • The last screw is located behind the flash module.

      • Turn the camera on, and raise the flash module to locate the flash module screw.

添加评论

  • Remove the 2 screws at the base of the camera housing.

    • Use the Phillips #00 Precision Screwdriver and remove the screws.

    • Repeat this process for the screw behind the flash module.

添加评论

  • Remove the screw located under the flash module using the Phillips #00 Precision Screwdriver.

添加评论

  • Remove the flash cover.

    • Remove the flash module by twisting it up and outward of the camera housing.

    • The cover can now be be removed.

添加评论

  • Remove the film door lever.

    • Remove the screw holding the film lever in place by using a Phillips #00 Precision Screwdriver.

    • Using a plastic opening tool, gently pry the switch upwards to remove it.

添加评论

  • Open the battery door by pushing the lever towards the arrow indicated.

添加评论

  • Remove the front cover.

    • Insert your thumb in the film hole and gently pry the bottom loose.

    • Once the front is loose, gently pull it out.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

David Cottrell

于2011年10月04日注册

58 信誉积分

创作了5篇指南

团队

UW Stout, Team 1-2, Zhou Fall 2011 UW Stout, Team 1-2, Zhou Fall 2011 的会员

UWSTOUT-ZHOU-F11S1G2

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 1

总计 517