简介

Prerequisite: Battery, uppercase, LCD screen

Flip the ThinkPad over so that it is upside down. Slide the highlighted tab to the left.
  • Flip the ThinkPad over so that it is upside down.

  • Slide the highlighted tab to the left.

  • With your finger on the tab, remove the battery by lifting it upwards away from the laptop.

添加评论

Make sure the laptop is upside down and oriented in the direction shown.
  • Make sure the laptop is upside down and oriented in the direction shown.

  • Remove the six 16.7mm screws inside the circled holes.

添加评论

Rotate the ThinkPad so that the hard drive bay is facing you.
  • Rotate the ThinkPad so that the hard drive bay is facing you.

  • Remove the black cover to reveal a 14.8mm screw.

  • Remove the uncovered screw with a Phillips #0 screwdriver.

添加评论

Flip the ThinkPad over and open the LCD panel. Pry apart the keyboard with a plastic opening tool or with your fingers.
  • Flip the ThinkPad over and open the LCD panel.

  • Pry apart the keyboard with a plastic opening tool or with your fingers.

添加评论

Be careful not to pull out the keyboard carelessly; there is a connector underneath it! Lift the front end of the keyboard as shown. Using your fingers, remove the black film cover.
  • Be careful not to pull out the keyboard carelessly; there is a connector underneath it!

  • Lift the front end of the keyboard as shown.

  • Using your fingers, remove the black film cover.

添加评论

Locate the connector attached to the motherboard. Disconnect the ribbon cable by removing the connector. Disconnect the ribbon cable by removing the connector.
  • Locate the connector attached to the motherboard.

  • Disconnect the ribbon cable by removing the connector.

添加评论

Lift and remove the keyboard. Remove the two 5.6mm screws.
  • Lift and remove the keyboard.

  • Remove the two 5.6mm screws.

  • Remove the 16.7mm screw.

添加评论

You will need to use a little force. Be wary of the tabs. Pry off the upper case with your hands. Pry off the upper case with your hands.
  • You will need to use a little force. Be wary of the tabs.

  • Pry off the upper case with your hands.

添加评论

Remove the 5.6mm screw that holds the LCD to the upper case.
  • Remove the 5.6mm screw that holds the LCD to the upper case.

添加评论

Remove the 5.6mm screw on the left side of the three-pronged connector. Remove the other two 16.7mm screws. Lift and remove connector.
  • Remove the 5.6mm screw on the left side of the three-pronged connector.

  • Remove the other two 16.7mm screws.

  • Lift and remove connector.

添加评论

Pull out the white tab connecting the LCD to the motherboard. Pull out the white tab connecting the LCD to the motherboard.
  • Pull out the white tab connecting the LCD to the motherboard.

添加评论

Turn the laptop so that the back is facing you. Remove the four 5.6mm long screws.
  • Turn the laptop so that the back is facing you.

  • Remove the four 5.6mm long screws.

添加评论

Place the laptop so that the LCD is facing you again. Gently lift the LCD monitor up and out. Remove the black plastic tab.
  • Place the laptop so that the LCD is facing you again.

  • Gently lift the LCD monitor up and out.

  • Remove the black plastic tab.

添加评论

Locate the 4 screws that will need to be removed.
  • Locate the 4 screws that will need to be removed.

  • One screw (yellow) is observable. The three other screws (red) are below the heatsink bracket.

  • Remove the 5.6mm (yellow) and three 16.1mm (red) screws.

添加评论

Lift the heatsink bracket up.
  • Lift the heatsink bracket up.

添加评论

Be careful not to pull too hard! There is a cable attached to the fan! Lift the fan/heatsink assembly up. Locate the fan power cable and pull upwards near the connector.
  • Be careful not to pull too hard! There is a cable attached to the fan!

  • Lift the fan/heatsink assembly up.

  • Locate the fan power cable and pull upwards near the connector.

  • Remove the fan/heatsink assembly.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Jessica

于2010年10月06日注册

159 信誉积分

创作了14篇指南

团队

Cal Poly, Team 4-44, Amido Fall 2010 Cal Poly, Team 4-44, Amido Fall 2010 的会员

CPSU-AMIDO-F10S4G44

4 名成员

创作了26篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 5

总计 2,241