跳转到主内容

Fix Your Stuff

Right to Repair

Parts & Tools

简介

This guide will show how to remove the back rim cover.

配件

没有特定配件。

  1. Place the plastic opening tool into the SD card slot or charge port. Try in an upward motion until you see a separation between the tablet and back cover.
    • Place the plastic opening tool into the SD card slot or charge port.

    • Try in an upward motion until you see a separation between the tablet and back cover.

  2. Work around the entire device by sliding the plastic opening tool around the rim.
    • Work around the entire device by sliding the plastic opening tool around the rim.

    • If this is the first time, it will be hard to separate the back cover from the tablet.

    • The clips are approximately 5 cm apart. While working around the device, the clips will make a dislocating sound when disconnected.

  3. Remove the back cover once all links have been separated.
    • Remove the back cover once all links have been separated.

    • Be careful when touching any of the internal components of the tablet.

  4. Place the plastic opening tool in between the outer rim. Move the tool in a downward motion to separate the 2 parts. Run the tool along the rim to disconnect all connectors holding the outer rim to the back of the device.
    • Place the plastic opening tool in between the outer rim.

    • Move the tool in a downward motion to separate the 2 parts.

    • Run the tool along the rim to disconnect all connectors holding the outer rim to the back of the device.

  5. Repeat this step for all four sides, then remove the rim.
    • Repeat this step for all four sides, then remove the rim.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Jordan Soto

于2015年08月26日注册

2,771 信誉积分

创作了6篇指南

团队

USF Tampa, Team 3-2, Eyestone Fall 2015 USF Tampa, Team 3-2, Eyestone Fall 2015 的会员

USFT-EYESTONE-F15S3G2

3 名成员

创作了18篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 104