简介

The flash device has a couple of delicate connections and should be handled with care.

配件

无需配件。

Remove the 2 screws(2.41mm long) on the side of the camera next to the LCD screen.
  • Remove the 2 screws(2.41mm long) on the side of the camera next to the LCD screen.

  • Remove the 2 screws(4.08mm) on the other side. One is located under the rubber USB flap.

  • Remove the last screw(2.59mm) located on the bottom of the camera.

  • Slowly pull the back cover of the camera.

添加评论

Remove the screw(2.59mm) from the bottom of the camera.
  • Remove the screw(2.59mm) from the bottom of the camera.

  • Remove the screw(4.08mm) from the menu button side of the camera.

  • The 2 screws on the other side of the camera were already removed when taking off the back cover.

添加评论

  • Unplug the green (if color-blind please ask someone for assistance) and white plugs connecting the top panel to top of the logic board.

  • Dislodge the tab above the lens.

  • Dislodge the back tab.

添加评论

  • Remove the screws(2.88mm) at the top right corner and bottom left corner of the LCD screen.

  • Disconnect the ribbons connecting the screen to the camera.

  • Remove the screen by lifting it off.

添加评论

  • CAUTION WHEN REMOVING FLASH. BE CAREFUL,THE CAPACITOR MAY STILL HAVE A CHARGE AND COULD SHOCK YOU.

  • Remove 2 screws(1.75mm) from the back with screwdriver, disconnecting the metal guard.

  • On top of camera, unplug the ribbon by pulling on it.

  • Disconnect the white plug connected by red and black wires by pulling on it.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Robert Manno

于2011年01月05日注册

432 信誉积分

创作了4篇指南

团队

Cal Poly, Team 13-3, Forte Winter 2011 Cal Poly, Team 13-3, Forte Winter 2011 的会员

CPSU-FORTE-W11S13G3

5 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 14

总计 2,277