简介

Use this guide to remove the back panel of the camera.

Place camera LCD side up and press up on the battery door.
  • Place camera LCD side up and press up on the battery door.

  • Let it swing open until you can see the battery inside.

添加评论

Press down on the orange plastic.
  • Press down on the orange plastic.

  • This will gently eject the battery from its compartment.

添加评论

  • Holding the edges, slide out the battery.

添加评论

  • Look at the camera from the side with the lanyard and 4 screws.

    • Remove the two 3.4 mm screws on the metallic colored part.

添加评论

  • Remove the 3mm screw on the top left.

    • NOTE: When reassembling, it is helpful to put the top screw back in before placing the front cover back on the camera.

  • Now remove the 5.3mm screw on the bottom.

添加评论

  • Place the camera LCD side down.

  • Remove the two 5.3mm screws by the battery door.

添加评论

  • Remove the four 3.4mm screws on the bottom of the camera around the tripod mount.

    • Make sure to keep these screws separate from the previous 5.3 mm screws.

添加评论

  • Stand the camera back up.

  • Remove the two 3.6mm screws on the side with the A/V Out port.

添加评论

  • Lift open the rubber flap covering the A/V Out port.

    • Remove the 3.4mm screw in the center.

    • During reassembly, put the A/V out rubber door on before replacing the front panel of the camera

添加评论

  • Use a spudger and gently open up the front panel of the camera.

    • A thin plastic ribbon will stay connected by a brown piece to front panel of the camera.

添加评论

  • There will be a brown plastic piece keeping the thin plastic ribbon in place.

  • Use the spudger to pull out the brown plastic piece attached to the orange plastic.

添加评论

  • Use a pair of tweezers and remove the metal piece inside the camera.

添加评论

  • Remove the battery door

    • NOTE: Putting this back on requires aligning the spring on the back of the door with the hole on the camera

添加评论

  • Using a spudger, gently separate the back panel from the rest of the camera and remove it.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Karim

于2012年04月12日注册

24 信誉积分

创作了3篇指南

团队

Cal Poly, Team 7-34, Maness Spring 2012 Cal Poly, Team 7-34, Maness Spring 2012 的会员

CPSU-MANESS-S12S7G34

5 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 4

总计 1,100