简介

The outer casing must be removed to replace any internal component of the Blackberry 8820.

To remove the outer casing of the Blackberry 8820, you must have a 1/16 inch diameter torx screwdriver ready as well as a plastic removing tool.

Remove the battery cover by applying pressure and sliding down to the silver square on the back of the phone.
  • Remove the battery cover by applying pressure and sliding down to the silver square on the back of the phone.

添加评论

Remove the battery by prying under it with your finger or the plastic opening tool.
  • Remove the battery by prying under it with your finger or the plastic opening tool.

  • Remove the four small 3/8" long screws using a 1/16" diameter torx screwdriver.

添加评论

  • Use a plastic opening tool (similar to the one shown) to carefully remove the two side bars of plastic.

添加评论

  • Use the plastic opening tool to carefully pry the back casing off.

    • There are two small clamps on each edge that need to be unhooked before the casing will come off.

添加评论

  • Pry off the front casing

    • Be aware of sensors and other sensitive areas of the newly exposed electronics

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

ryan

于2013年04月12日注册

41 信誉积分

创作了5篇指南

团队

Cal Poly, Team 13-64, Johann Spring 2013 Cal Poly, Team 13-64, Johann Spring 2013 的会员

CPSU-JOHANN-S13S13G64

4 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 649