简介

Replacing Hard Drive

配件

无需配件。

CAUTION:  If you remove the hard drive from  the computer when the drive is hot,  do not touch  the metal housing of the hard drive
  • CAUTION: If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive

  • CAUTION: Before you begin any of the procedur es in this section, follow the safety instructions in the Product Information Guide .

  • NOTICE: To prevent data loss, turn off your computer (see "Turning Off Your Computer" on page 9) before removing the hard drive. Do not remove the hard drive while the computer is on, in standby mode, or in hibernate mode

  • NOTICE: Hard drives are extremely fragile. Exercise care when handling the hard drive.

  • NOTE: Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.

  • NOTE: If you are installing a hard drive from a source other than Dell, you need to install an operating system, drivers, and utilities on the new hard drive

  • Turn the computer over, loosen the tw o captive screws on the hard drive cover, and then remove the cover.

添加评论

Loosen the four captive screws on the hard drive cage and then lift the  pull-tab to flip the cage towards the center of the computer so that the  SATA cables and connec tors are accessible.
  • Loosen the four captive screws on the hard drive cage and then lift the pull-tab to flip the cage towards the center of the computer so that the SATA cables and connec tors are accessible.

添加评论

Carefully remove the SATA cables from the hard drive or drives that are  installed in the cage.
  • Carefully remove the SATA cables from the hard drive or drives that are installed in the cage.

添加评论

MacBook Battery Fix Kits
Fix Kits Starting at $69.99
MacBook Battery Fix Kits
Starting at $69.99
Remove two screws on each side of  the hard drive cage to free the hard  drive, then lift the drive out of its tray in the cage.
  • Remove two screws on each side of the hard drive cage to free the hard drive, then lift the drive out of its tray in the cage.

  • NOTICE: When a hard drive is not in the computer , store it in protective antistatic packaging.

添加评论

Remove the new hard drive from its packaging. Save the original packaging for st oring or shipping the hard drive
  • Remove the new hard drive from its packaging. Save the original packaging for st oring or shipping the hard drive

  • Place the new hard drive into the drive cage tray and secure it with two screws on each side

添加评论

Place the hard drive cage upside down on the bottom of the computer with  the SATA connectors and ca bles aligned, and then  firmly press the cables  onto the hard drives’ connectors.
  • Place the hard drive cage upside down on the bottom of the computer with the SATA connectors and ca bles aligned, and then firmly press the cables onto the hard drives’ connectors.

  • NOTE: Ensure that the power connector cable is firmly secured to the mother board.

添加评论

Tighten the screws on the drive cage.
  • Tighten the screws on the drive cage.

添加评论

Replace the hard drive cover and tighten the screws.
  • Replace the hard drive cover and tighten the screws.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Johnathan Hammond

于2018年02月28日注册

357 信誉积分

创作了293篇指南

团队

Informative Technologies Inc. Informative Technologies Inc. 的会员

Community

15 名成员

创作了544篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 13

总计 13