简介

In this guide, we will be showing you how to remove and replace the Palm Rest.

配件

无需配件。

  1. Slide the left and the right battery release latches to the unlock position.
    • Slide the left and the right battery release latches to the unlock position.

  2. Slide the battery and remove it from the computer.
    • Slide the battery and remove it from the computer.

    • Loosen the screw that secures the memory door.

    • Pry up the memory door near the screw hole, lift and remove it.

    • If this is all you are doing Follow Step In Reverse if not Go to Next Step.

    • Remove the screw that secures the optical drive to the computer.

    • Gently pry the optical drive out of the computer.

    • Remove the screws that secure the optical drive bracket.

    • Remove the optical drive bracket from the optical drive module.

    • Remove the screws in the battery compartment.

    • Remove the screws in the optical drive compartment.

    • Remove the rubber from the bottom base on the right side.

    • Remove the rubber from the bottom base on the left side.

    • Remove all the screws from the bottom base.

    • Flip the computer around and remove the screws that secures the palm rest.

    • Release the latches on the system board connector, then disconnect the touch pad cable and the finger printer cable.

    • Release the latch on the system board connector and then disconnect the power button cable.

    • Release the latch on the system board connector and then disconnect the hot key cable.

    • Pry up the right side of the palm rest.

    • Pry up the left side of the palm rest.

    • Pry up the sides of the palm rest and remove it from the computer.

    • If this is all you are doing Follow Step In Reverse if not Go to Next Step.

终点

另外一个人完成了本指南。

Johnathan Hammond

于2018年02月28日注册

35,851 信誉积分

创作了408篇指南

团队

Informative Technologies Inc. Informative Technologies Inc. 的会员

Community

15 名成员

创作了925篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 25