简介

In this repair guide you will be able to install a new mother board into the printer.

  1. Rotate the photo printer so that the bottom of the case faces upward.
    • Rotate the photo printer so that the bottom of the case faces upward.

    添加评论

  2. Use a Phillips #2 screwdriver to remove the three 5.65 mm screws on the bottom panel of the case in a counter-clockwise fashion.
    • Use a Phillips #2 screwdriver to remove the three 5.65 mm screws on the bottom panel of the case in a counter-clockwise fashion.

    添加评论

    • Rotate the device so that it is upright again. Under the LCD Panel there is a 9.62 mm screw, unscrew using a Phillips #2 screwdriver.

    添加评论

    • Remove the back panel of the case by pulling directly back.

      • Some carefully applied force may be required to remove this part.

    添加评论

    • Rotate the photo printer so that the bottom panel faces up once again. Now lift off the bottom panel of the case to access all internal components.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Finally remove the side panel with the ink-cartridge door by holding the right side and pulling backwards with the left side.

      • Caution! The side panel is held in by tabs; don't break these.

    添加评论

    • Carefully remove the inner components of the device by lifting the inner components up and out of the casing.

    添加评论

    • Locate the red and black cable that is connecting the fan to the top of the logic board.

    添加评论

    • Carefully, remove the red and black cable from the logic board by pulling gently in order to isolate the cooling fan from the device.

    添加评论

    • Locate the data ribbon that connects the LCD panel to the mother board.

    • Loosen the fasteners next to the ribbon by carefully pushing them away from the white ribbon holder.

      • Once the fasteners are loosened the ribbon should easily slide away from the motherboard.

    添加评论

    • Locate the clips with multi-colored wires that connect the motherboard to the printing unit.

      • Disconnect both of them by gently pulling them away from the motherboard.

    添加评论

    • Locate the white ribbon that connects the motherboard to the printing feed.

    • Disconnect the ribbon by gently pulling the ribbon away from the motherboard.

    添加评论

    • The mother board has changed orientation. Notice the new orientation based on the white data ribbon we removed in the previous step.

    • Locate the black data ribbon that connects the mother board to the printing motors.

    • Disconnect it from the logic board, by gently pulling the wire away from the mother board.

    添加评论

    • Now unscrew the three screws 7.89mm (counter-clockwise) using a Phillips #1 screwdriver.

    添加评论

    • Once screws and ribbons are disconnected, you can pull mother board away from the printing unit.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Cory Peterson

于2012年04月04日注册

133 信誉积分

撰写一个指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 572